What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Engine baffle ignition wire seal

Greg Arehart

Well Known Member
Mine are starting to crack a bit and am thinking of some preventive maintenance. I looked at these on ACS and they want $28.55 for a set of these little plastic buggers! And that's only good for two wires. I need two sets of these, so that's over $50 for a few tiny pieces of plastic.

I've looked for alternate sources on the internet, but no luck so far. Anyone else have a reasonably-priced source? Someone printing these with a 3D printer?

Thanks,
Greg
 
I use rubber grommets. Can?t get much less expensive than that. I think I?ve replaced them once in the last 10 years

Erich
 
I made a couple sets for my 6A from a chunk of plastic cutting board. Used drill press and bandsaw. Use 4 screws instead of 2
 
Back
Top