Anton Lawrenz
I'm New Here
It appears I have reamed the flap attachment hole in the flap hinge bracket a fraction too large. Before priming I could push the brass bushings in and out by hand using moderate pressure. I know these bushings should be interference fit so that bushing does not rotate. After priming with epoxy primer the paint has reduced the hole size and the bushings would now have to be pushed in with a press.
1) Is this OK? I would push bushings in wet with epoxy primer.
2) Should I machine new bushings to fit.
I have asked Vans for advice as well.
1) Is this OK? I would push bushings in wet with epoxy primer.
2) Should I machine new bushings to fit.
I have asked Vans for advice as well.