What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Roll servo bolts

edhunter

Well Known Member
Apologies if this has been answered before, but a search did not show what I was looking for... I need to replace a roll servo, going from Garmin to Dynon. I found this pic today in the forsale section, which made me think of it...
Question: The two bolts holding the mounting bracket in the wing, do these have nuts on the backside, or do they bolt into nut plates? Did not want to loosen as did not see an easy way to get to the other side if are held with nuts, although logic would dictate a nut plate of sorts... Did not build...
Thanks, ed
 

Attachments

  • 64A01898-DD27-4C0D-BF8A-9A4E74C7220E.jpg
    64A01898-DD27-4C0D-BF8A-9A4E74C7220E.jpg
    11.4 KB · Views: 605
There are nut plates. See attached.
 

Attachments

  • Screen Shot 2021-06-03 at 1.40.19 PM.png
    Screen Shot 2021-06-03 at 1.40.19 PM.png
    306.7 KB · Views: 224
The screw holes match up to the nutplate on the wing web. This is on my right wing. The servo control arm is connected to the aileron control horn.
 

Attachments

  • 20210603_124131.jpg
    20210603_124131.jpg
    144.3 KB · Views: 194
Curious why the swap out ? I’ve flown both .

Bought a partial built kit with a friend of mine. Wings came with the garmin servo installed. Got a good deal on a full advanced setup, including the dynon servos. Hence the swap.
 
Dynon

Bought a partial built kit with a friend of mine. Wings came with the garmin servo installed. Got a good deal on a full advanced setup, including the dynon servos. Hence the swap.

Nice , I’m always looking for a good deal , waiting till last minute to get the panel ordered I’m probably a year away with the slow build :(
 
Back
Top