I'm at that stage of the build where the decision tree gets more complicated. (Chapter 29 - Fuselage where you can actually start to envision this thing is an airplane)
My current thoughts are around Avionics / Fuselage wiring. I have heard that while the fuselage is open is the best time to run the wiring, and also that you can either buy the harness from Stein or others or make it yourself, but of course that depends on what options you need, etc (more decisions).
I am leaning Garmin although what I have seen with the AFS and the quickpanel is appealing as well. It may not matter really at this stage.
- What's the best or perhaps latest time in the build to run these wires?
- Stein is the obvious choice but have others used other places to build a harness?
- Do it yourself is an option but having seen a recent post here - I am thinking time savings vs cost favors pre-built.
To clarify: I am talking about the fuselage harness for the wiring that runs through that, rather than the panel itself at this point.
My current thoughts are around Avionics / Fuselage wiring. I have heard that while the fuselage is open is the best time to run the wiring, and also that you can either buy the harness from Stein or others or make it yourself, but of course that depends on what options you need, etc (more decisions).
I am leaning Garmin although what I have seen with the AFS and the quickpanel is appealing as well. It may not matter really at this stage.
- What's the best or perhaps latest time in the build to run these wires?
- Stein is the obvious choice but have others used other places to build a harness?
- Do it yourself is an option but having seen a recent post here - I am thinking time savings vs cost favors pre-built.
To clarify: I am talking about the fuselage harness for the wiring that runs through that, rather than the panel itself at this point.
Last edited: