I can't say if the Tail Dragger Dragger will work with our tailwheels or not. If they work with the standard Van's tailwheel, I wouldn't see why not.
If there were more hours in the day, I'd offer this tailwheel towbar. It's super CHEAP, super easy to use, and absolutely won't pop off unexpectedly.
http://www.vincesrocket.com/Additions%20after%2010-27-04.htm Scroll downa little ways to the towbar section.
I'll try to add the text and photos here so everyone doesn't have to go hunting.
Quote:
The standard Cessna 150 towbar (ACS p/n 13-01800, $34) works fine with the Screaming Eagle tailwheels. Or you can roll your own for about $5. See below. It's made from ordinary electrical conduit. Just make sure that the conduit you buy will fit over the nut/bolt in your tailwheel.
Strap loose. Ready to install.
Strap tight. Ready to use. You could fly to Alaska and back and the tow bar would still be attached.
|
The strap is simply a bent piece of scrap aluminum, probably .025", with a small bolt holding the ends together.
To use, place the ends over the tailwheel bolthead and nut, squeeze the towbar together with your hand, slide the strap down. Easy hand pressure is all that is needed. It
won't come loose!
A little cutting and welding is required, but it's easy enough. Doesn't have to be pretty, just sturdy. A quick spray of silver paint will dress everything up.
__________________
Vince Frazier
www.f1aircraft.com
F1 Rocket and F4 Raider components
1-888-F1AIRCRAFT (1-888-312-4727)
www.flyboyaccessories.com
RV and Rocket Accessories, Tailwheels, Tools, & More
1-888-8FLYBOY (1-888-835-9269)
F4 Raider - under construction
F1-H Rocket "Crazy Horse" - sold
RV-4 "Chief Pontiac" - sold in 1994, purchased in 2018