Cowling Fasteners Updated - Page 5

Dennis Fox · #41 03-28-2008, 12:56 PM

Im in for the VAF Group Buy, im building a 0360, RV7A, standard cowling.

Complete Set 7A Phillips.

Let me know.

Dennis Fox.

Altus, OK

VAF# 1117

Thatchman · #42 03-31-2008, 08:05 AM

Thanks, to everyone who participated this time around. Today 03-31-2008 is the last day of the group buy so, if anyone wants to get in at the last minute, please let me know.

Best,
Jeremy
MilSpec Products, Inc.
Tel. 352-735-0065
Fax 352-735-0504
www.milspecproducts.com

GrayHawk · #43 03-31-2008, 08:11 PM

Better late than never, it's only 10:10PM Florida time.
Full set RV-6A
PM/email will be sent.

qtrmiledan · #44 03-31-2008, 09:34 PM

Count Me In!!! PM sent! Thanks!!!!

Thatchman · #45 04-09-2008, 04:04 PM

Sorry for the delay but, with all the exchanges plus the group buy hitting us all at once we actually ran out of some components. Honestly I didn?t expect this big of a response (Thanks!). Not to worry though, we are back up to speed on production and should have everyone shipped within a week. Thank you for your patience and if there is anything else I can do please let me know.

Thanks!
Jeremy
MilSpec
T 352-735-0065
Mobile: 407-595-7385

apatti · #46 04-09-2008, 09:19 PM

Jeremy,
Thanks for the update.

Bill Dicus · #47 04-10-2008, 03:41 PM

Jeremy: Maybe too late. But.... could you let me know what it would cost for my RV-8 for the firewall end of the upper cowl and the flat bottom firewall segments of the lower cowl?I'd take your advice on materal - SS vs ? but would prefer Phillips screw heads. Thanks in advance - Bill

Thatchman · #48 04-10-2008, 06:53 PM

Bill,

Our normal FW only, Philips kit for your RV8 is $278.80. The price after the VAF group buy 30% discount is $195.16. This would include 28 fastener sets (stainless, Phillips head studs, grommets, retainers, aluminum adjustable depth receptacles, drill templates, instructions and all the product support you can handle). This is of course assuming that you want to do the entire FW section at the recommended 3.5” – 4” spacing between fasteners. However, if I understand your preference correctly, you want the top FW and lower, side FW locations only, with the belly portion of the FW being some other method of fastening. If this is correct, we can adjust the fastener count to whatever you specify. It seems to me that the count in this configuration would be decreased by 4 – 6 total. If you can verify my logic or tell me where I got off track, I can adjust the count and therefore the price(s) to your preference. Give me a call if you like so we can discuss it further.

Best,
Jeremy
MilSpec
T 352-735-0065
Mobile 407-595-7385