What befuddles me is that the servo control arm darn-near travels 180 degrees, causing over-centering. If it over-centers to the left, I make small push rod adjustments to fix it but then it will over-center to the right!
What am I missing!!!??? I was particular in following the above instructions - or so I think....
What befuddles me is that the servo control arm darn-near travels 180 degrees, causing over-centering. If it over-centers to the left, I make small push rod adjustments to fix it but then it will over-center to the right!
What am I missing!!!??? I was particular in following the above instructions - or so I think....
Thank you!
First, you used a Dynon manual for installing a different manufacturers servo; Generally best to use the manual that matches the product. Move the heim joint to a hole closer to the pivot on the servo arm. That will reduce the arm travel
__________________
N64LR - RV-6A / IO-320, Flying as of 8/2015
N11LR - RV-10, Flying as of 12/2019
TruTrak roll servo OVER-CENTER
Linear Mode
