|
-
POSTING RULES

-
Donate yearly (please).
-
Advertise in here!
-
Today's Posts
|
Insert Pics
|

11-18-2019, 09:15 AM
|
 |
|
|
Join Date: Sep 2015
Location: Oregon
Posts: 801
|
|
Quote:
Originally Posted by jcarne
Yep I used the stuff that Van's sells. Just a replacement for the old. Works great.
|
Roger that! I have to get down there today for some parts, so I will pick up a small kit.
__________________
Kentlik
RV-7A in progress
http://www.imdb.com/name/nm0527486/?
Private pilot, ASEL!
EAA 105 Chapter 7S3
Bi-annual financial contributor
"The credit belongs to the man who is actually in the arena..." Teddy Roosevelt
|

11-28-2019, 09:47 AM
|
 |
|
|
Join Date: Sep 2015
Location: Oregon
Posts: 801
|
|
Pitot
I had a bit of time and ran my AOA and Pitot lines. Hope this works as not sure of the throw of elevator bell crank...
[IMG] pitot by Kent Luttrell, on Flickr[/IMG]
[IMG] pitot2 by Kent Luttrell, on Flickr[/IMG]
__________________
Kentlik
RV-7A in progress
http://www.imdb.com/name/nm0527486/?
Private pilot, ASEL!
EAA 105 Chapter 7S3
Bi-annual financial contributor
"The credit belongs to the man who is actually in the arena..." Teddy Roosevelt
|

11-28-2019, 10:24 AM
|
 |
|
|
Join Date: Jul 2016
Location: Worland, Wyoming
Posts: 1,365
|
|
Looks pretty good there brother! I think you should have plenty of clearance, good idea supporting it close to that radius too.
__________________
Jereme Carne
PPL
RV-7A Emp. done
Wings done
Fuselage done
Finish kit almost done
Exempt but gladly paying!
|

11-29-2019, 11:23 AM
|
 |
|
|
Join Date: Sep 2015
Location: Oregon
Posts: 801
|
|
Quote:
Originally Posted by jcarne
Looks pretty good there brother! I think you should have plenty of clearance, good idea supporting it close to that radius too.
|
Thanks, Jereme! I had looked around at other designs and this seemed a good fit for my plane. The radius fittings at the bottom seemed the best solution if I could control it without too much hardware. Slow but steady...
__________________
Kentlik
RV-7A in progress
http://www.imdb.com/name/nm0527486/?
Private pilot, ASEL!
EAA 105 Chapter 7S3
Bi-annual financial contributor
"The credit belongs to the man who is actually in the arena..." Teddy Roosevelt
|

12-19-2019, 04:43 PM
|
 |
|
|
Join Date: Sep 2015
Location: Oregon
Posts: 801
|
|
servo brkt
Got some time away from figuring out electrical to pound a few rivets. I had to use some existing holes for the servo brkt so not quite even but it will work just fine.
[IMG] IMAG1003 by Kent Luttrell, on Flickr[/IMG]
[IMG] IMAG1030 by Kent Luttrell, on Flickr[/IMG]
Over drove one, maybe two but it will be ok, rivets were a bit long...
[IMG] IMAG1033 by Kent Luttrell, on Flickr[/IMG]
There are marks from my pen on the angle, it doesn't look too good but I doubt anyone will see them.
[IMG] IMAG1031 by Kent Luttrell, on Flickr[/IMG]
__________________
Kentlik
RV-7A in progress
http://www.imdb.com/name/nm0527486/?
Private pilot, ASEL!
EAA 105 Chapter 7S3
Bi-annual financial contributor
"The credit belongs to the man who is actually in the arena..." Teddy Roosevelt
|

01-03-2020, 07:15 PM
|
 |
|
|
Join Date: Sep 2015
Location: Oregon
Posts: 801
|
|
Very initial panel ideas. Disregard the round gauge designations. One will be for the SDS programmer. The others are TBD. I have both an airspeed and altimeter gauge that may or may not be used.
[IMG] IMAG1008 by Kent Luttrell, on Flickr[/IMG]
[IMG] IMAG1044 by Kent Luttrell, on Flickr[/IMG]
[IMG] IMAG1047 by Kent Luttrell, on Flickr[/IMG]
[IMG] IMAG1043 by Kent Luttrell, on Flickr[/IMG]
__________________
Kentlik
RV-7A in progress
http://www.imdb.com/name/nm0527486/?
Private pilot, ASEL!
EAA 105 Chapter 7S3
Bi-annual financial contributor
"The credit belongs to the man who is actually in the arena..." Teddy Roosevelt
|

01-07-2020, 06:49 PM
|
 |
|
|
Join Date: Sep 2015
Location: Oregon
Posts: 801
|
|
SDS
Decided on left placement of SDS programmer. Hole placement set for GRT MINI X or other in the future.
[IMG] IMAG1050 by Kent Luttrell, on Flickr[/IMG]
__________________
Kentlik
RV-7A in progress
http://www.imdb.com/name/nm0527486/?
Private pilot, ASEL!
EAA 105 Chapter 7S3
Bi-annual financial contributor
"The credit belongs to the man who is actually in the arena..." Teddy Roosevelt
|

01-08-2020, 06:48 AM
|
 |
|
|
Join Date: Jul 2016
Location: Worland, Wyoming
Posts: 1,365
|
|
Let it begin! 
__________________
Jereme Carne
PPL
RV-7A Emp. done
Wings done
Fuselage done
Finish kit almost done
Exempt but gladly paying!
|

01-09-2020, 08:36 PM
|
 |
|
|
Join Date: Sep 2015
Location: Oregon
Posts: 801
|
|
Quote:
Originally Posted by jcarne
Let it begin! 
|
Yes, it begins...
I am piecing together an idea and following a simple plan of one bite at a time.
__________________
Kentlik
RV-7A in progress
http://www.imdb.com/name/nm0527486/?
Private pilot, ASEL!
EAA 105 Chapter 7S3
Bi-annual financial contributor
"The credit belongs to the man who is actually in the arena..." Teddy Roosevelt
Last edited by kentlik : 01-09-2020 at 08:37 PM.
Reason: grammar
|
| Thread Tools |
Search this Thread |
|
|
|
| Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -6. The time now is 03:19 AM.
|