Quote:
Originally Posted by mdaniell
I'm using .18 which works fine. I'm told vers .19 just has support for a box I don't have, sorry can't remember what it was. If you don't need .19 then the painful task of loading .18 might fix it.
Martin
|
I doubt that installing the .18 revision will help. Since I posted I've come to the conclusion that I may have to enter a value on the fuel calibration page for the K factor of the Red Cube. The Hotel revision of the manual isn't too specific; They mention the 'flo-scan' sensor but Spruce talks about the k factor of the red cube being 68000 and using 680 as a programming figure.
I would think that if you configured the flow transducer for the FT60 that would automatically set the k factor but maybe not.
-Marc