Surprising they don't have a spacer under that plate. I made two spacers with good area and tested for reaching the specified torque, it would not torque with standard washers for me. I also used a bed of proseal for good measure. It is a 7 but uses the same weight.
Off topic: I cast some lead weights and found that with a cold mold the lead would pillow like these. If the mold was preheated, the parts were smooth like the mold.
__________________
Bill
RV-7
Lord Kelvin:
“I often say that when you can measure what you are speaking about,
and express it in numbers, you know something about it; but when you
cannot measure it, when you cannot express it in numbers, your knowledge
is of a meager and unsatisfactory kind.”
|