Where Can I Get a Crimper for This?

[Cyclone]

Originally Posted by az_gila

I like the bit in the instructions that specify a difference of 15.4 thousands of an inch difference in stripped wire length for the two types of pins.

Someone must have much better measuring tools than I have.

Or as an aged structural engineer used to accuse us young bucks with the new
fangled calculators ?you guys measure with a micrometer and cut it off with an
axe?.

[az_gila]

Originally Posted by Cyclone

Or as an aged structural engineer used to accuse us young bucks with the new
fangled calculators ?you guys measure with a micrometer and cut it off with an
axe?.

If they actually quoted a tolerance we could allow for the width of the axe....