My stick wires are at least 6" too short and even then there would not be a lot of freedom of movement. The main wire bundles that extend up to the panel may be long enough to reach the centre avionics but there certainly will not be enough to reach switches and breakers. Thus more connections and future potential failure points will be required. The small molex connectors are not user friendly and it would be much better to use D-sub type connectors for them.
The wiring harness is to me, the only little black cloud in the whole kit.
To end on a good note; the wiring harness diagram is available from the website and I was able to get a local printer to print it full size, 3' by 4', and with the labels on the wire ends tracking down issues should be easier.
__________________
Tom Martin RV1 pilot 4.6hours!
CPL & IFR rated
EVO F1 Rocket 1000 hours,
2010 SARL Rocket 100 race, average speed of 238.6 knots/274.6mph
RV4, RV7, RV10, two HRIIs and five F1 Rockets
RV14 Tail dragger
Fairlea Field
St.Thomas, Ontario Canada, CYQS
fairleafield@gmail.com
|