Possible AD for certain NAVWORX ADS-B Units

[BobTurner]

Isn't the Dynon transponder actually manufactured by Trig?

[az_gila]

Originally Posted by BobTurner

Isn't the Dynon transponder actually manufactured by Trig?

Yes, but I didn't see that as an option either...

[dynonsupport]

Gil,
I just checked and Dynon is on the pull down, and as far as we knew, has been for a long time. What page are you at where you can't find it?

You are supposed to enter Dynon, not Trig. Our transponder has a unique part number.

https://adsbperformance.faa.gov/PAPRRequest.aspx

[GalinHdz]

Originally Posted by keijidosha

I flew this morning and just requested a report. I'm pretty sure this is a new question as I don't remember answering it in the past;

"Please provide the Installer of your ADS-B OUT Equipment. ADS-B OUT Equipment Installer
*Installer Category:
Repair Shop
Airframe Powerplant Mechanic
Factory Installed
Self Installed - Experimental
Self Installed - Light Sport
Not Known
[*Denotes required input.]"

Repair Shop, Mechanic ask for State, City, and Shop/Mechanic name.

FWIW, my report came back No Exceptions, as usual.

WAY before that point on the FAA page, you need to pick which ADS-B OUT Data link(s) you have. If you have a DYNON, select 1090ES which is what their transponder's frequency. THEN you can select DYNON under <MANUFACTURER>. DYNON does not manufacture a UAT unit so if you select that option, it doesn't show up.

REMEMBER the FAA is only interested in ADS-B OUT, they don't care about ADS-B IN.

[phobos_49]

If you're configuration is set to "anonymous " the FAA system can't find your record and will not generate a report.
Reconfigure to show your N number and you should get a report in minuets.

[BobTurner]

Originally Posted by phobos_49

If you're configuration is set to "anonymous " the FAA system can't find your record and will not generate a report.
Reconfigure to show your N number and you should get a report in minuets.

Since he's talking about a mode S-ES transponder, "anonymous" is not an option.

[Billvt]

Jarhead was correct.

My Navworx ADS600-EXP was in the stealth mode.

I had switched to that mode a few months ago and had forgotten about it.

Problem of no ADS-B reports, solved.

Bill

[roadrunner20]

Navworx has updated their website.
See my new thread.
http://www.vansairforce.com/communit...hlight=Navworx

[Swoda]

The following is a link to a new letter from the FAA Manager of the Helicopter Directorate on the Status of the NAVWORX NPRM. It was posted yesterday.

https://www.regulations.gov/document...2016-9226-0203

[GalinHdz]

WOW, this thread has over 101,000 views and 475 posts in less than 7 months.