Conduit runs

[sritchie]

Originally Posted by Mike S

Sam, all depends on what you to have and where you want it installed.

Nice! Those wire bundles look great. Looks like I can get by with terminating the conduit in some place I can access by hand, seal the floors and call it a day.

Thanks for the great pictures! Jealous of those heated seats

[rdamazio]

One more option to not leave the conduits just hanging in the holes is Panduit LHMS-S5-C (available here at mouser.com).

This picture from mouser(.org) shows them:



I'm using those with success, though riveting them is a bit tricky (the rivet expands a bit inside the plastic).

[Bill Boyd]

if Mouser is getting $4.69 each for these puppies, or for a bag of 100.

[goanddo]

First, thank you to everyone who has added to this thread. The following picture is of my rv10. I would like to do as Mike Starkey has done and run my conduit strait up from the back under the flap torque tube cove. However, on mine I was hoping to run two hoses (one on each side) inside of the conduit Mike has run. I would have a total of four straight runs. I also understand holes more toward the center (of the length of the span) may not be as good of a choice as more toward the outside of the span. My holes will be 1 inch OD. Does any body have a FLYING airplane where this configuration has been done? Four one inch OD holes in the rear spar bulkhead? If so, please I would be thrilled to hear. Thank you!!

Sincerely grateful,
Ron Searle