Just a note. My Dynon probe clamps have shed two ends in 75 hours. One was laying in the bottom cowl, the other vanished....Wonder why they're breaking off?
Tempted to cut the other two off, and probably will.
Last edited by flyingriki : 09-07-2016 at 08:19 PM.
If these are the band screw type, you can safety them by placing a peace of .021 or .032 wire under the clamp, tighten the screw, then run the wire through the screw driver slot to keep it from turning from vibrations.
Hope this helps. Yours, R.E.A. III #80888
If these are the band screw type, you can safety them by placing a peace of .021 or .032 wire under the clamp, tighten the screw, then run the wire through the screw driver slot to keep it from turning from vibrations.
Hope this helps. Yours, R.E.A. III #80888
All my clamps are safetied. These are the excess ends of the bands.
I just had this done due to vibration issues. Miraculously smoother. And if you don?t have a vibration issue, you will know that too. Not sure where you are in CA. I used JF Dynamics. Completely satisfied. http://www.jfdynamics.com/
__________________
Matt
Simi Valley, CA
RV-4 O-320 F/P
EGT Probes
Linear Mode
