The demonstrator had the same design I posted on page 4 of this thread except instead of the three top rivets it had the two top and the one below to form a triangle to anchor it and it was made of aluminum. I finished my first concept by using larger rivets, rounding the sheep hook, painting to match and adding a piece of heat shrink tubing for cushioning at the handle contact point.
__________________
Scott- 2020 donation
New RV-7A N579RV, only 80 hours now without 2020 fly-in destinations
Built RV-12, 328 hours-sold, purchased RV-12 sold, Built RV-9A, 536 hours-sold, Not completed RV-7 sold, Built Kitfox sold
|