Brand new RV7A. Superior IO-360 and a Hartzell 2 blade prop with a Hartzell CSU. I have set the Dynon on 1 pulse per revolution which seems to be right, but I am not sure.
When I do a run up the CSU will only cycle at 1900RPM or higher. Is this normal?
__________________
Jan Hanekom
South Africa
Approved Person nr 325 http://www.rvbits.com
RV10 - ZU-XOX - (Flying)
RV7A - ZU-JRV - (Flying)
RV10 - ZU-JVR - (Written off)
RV7 - ZU-LOL - (Flying)
RV10 - ZU-RVI - (Flying)
RV7A - ZU-MER (Bought back)
RV7A - ZU-JAD (Sold Flying)
Dues paid for 2020 WITH A SMILE
Yes, common for that to occur. On my Jihostroj governor I got it to cycle at about 1500 but I understand that is pretty far on the low RPM end of the spectrum to see it work.
__________________
Greg Niehues - SEL, IFR, Repairman Cert.
Garden City, TX VAF 2020 dues paid
N16GN flying 700 hrs and counting; IO360, SDS, WWRV200, Dynon HDX, 430W
Built an off-plan RV9A with too much fuel and too much HP. Should drop dead any minute now.
CSU - RPM question
now N281CT
Linear Mode
