Other posters have said they received RV-7 engine mounts for their old RV-6 kits.
The RV-6 dimensions are almost a rectangle that is 37 1/8 wide at the top, 37 3/8 wide at the bottom and 19 3/8 high (1989 sheet 50).
The two lower holes are displaced 3/4 inch down and measure 13 13/16 and a further 9 3/4 from the lower corner hole on the pilot's side.
__________________
Gil Alexander
EAA Technical Counselor, Airframe Mechanic
Half completed RV-10 QB purchased
RV-6A N61GX - finally flying
Grumman Tiger N12GA - flying
La Cholla Airpark (57AZ) Tucson AZ
Last edited by az_gila : 08-15-2015 at 12:09 PM.
|