My AntiRotate toggles use a washer with two rectangular tabs. One internal tab fits in a slot in the switch body, the other is external and fits into a slot cut in the panel. The result is a switch that will not rotate when attached to the panel. Desirable to me.
How does one cut the small rectangular hole in the panel for the anti-rotate tab to fit into? Just drilling a hole for the tab to fit into comes to mind, but if there is a reasonable way to make the hole the shape of the tab, that would be preferable. Square drill?
How does one cut the small rectangular hole in the panel for the anti-rotate tab to fit into? Just drilling a hole for the tab to fit into comes to mind, but if there is a reasonable way to make the hole the shape of the tab, that would be preferable. Square drill?
Last edited: