View Single Post
Old 02-17-2016, 09:05 AM
davestapa davestapa is offline
Join Date: Apr 2007
Location: Woodstock, GA
Posts: 29
Default Dynon & Vertical Power Issue

We have a RV-10 that has Dynon SkyView and VP-X installed. We have talked to Dynon & Vertical Power about an issue with the trim indicator. We have loaded the VP-X Configurator and set limits to 1 as instructed and did the trim settings in the SkyView. The trim indicator on the screen shows up, but the arrows are either at the top or bottom of the scale and do not move with the trim changes. Dynon says it's a VP-X issue and Vertical Power says it needs to be corrected on the SkyView settings. Anyone else have this issue, or have any ideas.
David E
Woodstock, GA
RV-9A N97KE Rehomed
Kitfox 5 N97DE Grounded
RV-10 N96KE Flying
Reply With Quote