View Single Post
Old 04-13-2021, 03:57 PM
agent4573 agent4573 is offline
Join Date: Aug 2019
Location: Mountain view
Posts: 346

Can you take a picture a little further away? Having a hard time picturing exactly where this is in the structure. From what I can see, I would personally file the skin back so its not pressed against the reinforcement bar, but I also don't remember any of my skins having an intereference fit like that. It looks like you may have to take a few rivets out in order to gain access to the edge of the skin. What was your plan for getting a dremel or file in there?

Edit: Also, if I wanted to go look at the drawing for this part, could you confirm you're building an RV9 and the drawing number?
N69ER - reserved

Last edited by agent4573 : 04-13-2021 at 04:04 PM.
Reply With Quote