View Single Post
Old 05-23-2013, 05:55 AM
LAMPSguy's Avatar
LAMPSguy LAMPSguy is offline
Join Date: Feb 2008
Location: Pensacola, FL
Posts: 374
Default Aluminum tags alumiprep

I found some inexpensive pre-numbered valve tags online (.050 Al with # etched into it, no anodize). I was thinking of using these for parts identification while alumipreping and alodining. Will they be single use, or is it ok to put a freshly alodined small piece (size of quarter) right back into alumiprep. They are cheap enough that it wouldn't be too bad to throw away if needed or better for alumiprep longevity.
RV-? in planning stages.
RV-14 #140050 SOLD

Permanently willing to contribute fuel for RV rides

Helicopter ATP/CFI(I)
ASEL/AMEL Commercial/Inst/CFI(I)
Aerobatic Instruction available

Atlanta based.
Reply With Quote