View Single Post
Old 02-07-2021, 02:44 PM
NinerBikes NinerBikes is offline
Join Date: Dec 2018
Location: Granada Hills
Posts: 1,132

And I believe, it's port 4 ? Also, was your wiring harness built with the shielded data cable that goes from the box to GTR225 ? Also make sure the baud rate is set correctly.

I know, having an early RV-12 and box, for my SL-40, I had to buy an additional separate shielded cable from Van's to get that information to show up at the top of my Map, as it was not included in the original wiring harness, but was subsequently added later on, in production. You could probably make your own cable, later on, folks said the shielding wasn't necessary, just need the pins, and pinout locations.
2012 RV-12, #212 N72DJ KWHP based.

Last edited by NinerBikes : 02-08-2021 at 10:24 AM.
Reply With Quote