View Single Post
Old 12-28-2020, 02:59 PM
Ron B. Ron B. is offline
Join Date: Nov 2007
Location: Yarmouth, Nova Scotia
Posts: 2,511

Not an engineer and you should pass this suggestion through Van's, but could you drill out three rivets leaving a hole in the tapered part of the rivets with no stem? Like tapered bushings and glue them in the counter sinks holes to fill the holes , then put the called out rivets through the assembly ? Just a thought where as there is plenty of material for strength.
Thanks Ron
RV-14 Flying
AirCam flying
Reply With Quote