View Single Post
  #4  
Old 01-07-2017, 04:37 PM
Reflex Reflex is offline
 
Join Date: Jan 2015
Location: Kansas
Posts: 208
Default

Gentlemen,

Thanks for the input. I'll use the MK-319BS rivets.

Regarding the rivet height, I agree, they look thin. However they fit perfectly in the gauge. I've found that some of the call-outs can be just a tad short (and some a bit long). In this case, 3-3.5's were specified. Going through the skin, R00904B-1, and R-00918 seemed like a bit of a stretch. They looked short so I checked them with calipers....they were of proper length so I used them.

Should I drill out and use 3-4's? Hate to drill out that .016 skin.

Thanks,

Fred
__________________
Dues Paid for 2022
RV-14
Emp Complete (including fiberglass)
Wings complete (including fiberglass)
Fuse Complete
Working on Finishing Kit
Working on Avionics

Last edited by Reflex : 01-07-2017 at 04:46 PM.
Reply With Quote