View Single Post
  #7  
Old 12-17-2014, 12:08 PM
Mike S's Avatar
Mike S Mike S is online now
Senior Curmudgeon
 
Join Date: Sep 2005
Location: Dayton Airpark, NV A34
Posts: 16,309
Default

Quote:
Originally Posted by AndyRV7 View Post
Are there any torque specs I need to adhere too?
Yes, wheel halves bolts, brake caliper half bolts, for sure. Hopefully you have the plans. Or, maybe someone here has the specs for your plane.

The axle nut-----------run it down until solid drag on the wheel as you spin it, then bump the tire a few times on the sidewall just in case-----and rotate again to see if it changed when you bumped it. After it is seated back off the nut just enough to relieve the drag on the spinning tire, and insert the cotter pin.
__________________
Mike Starkey
VAF 909

Rv-10, N210LM.

Flying as of 12/4/2010

Phase 1 done, 2/4/2011

Sold after 240+ wonderful hours of flight.

"Flying the airplane is more important than radioing your plight to a person on the ground incapable of understanding or doing anything about it."
Reply With Quote