View Single Post
  #5  
Old 11-26-2019, 07:39 PM
RV701775 RV701775 is offline
 
Join Date: Jul 2019
Location: Boston, MA
Posts: 95
Default

One issue I noted is that the dimples on the stiffener are slightly tipped inward. I believe this is due to the proximity of the bend in the stiffener. I also tried using a dimple die that was ground down on one side and did not see much improvement. I believe this tilt in the dimple may be why, that although the rivet is set straight, the outer side of the shop head is shorter than the inside side.
Reply With Quote