View Single Post
  #8  
Old 01-31-2018, 02:04 PM
greghughespdx's Avatar
greghughespdx greghughespdx is offline
 
Join Date: Nov 2011
Location: Aurora, OR
Posts: 1,167
Default

Quote:
Originally Posted by Robin8er View Post
If you search the paper clip method its basically the same idea. The problem, at least on my 8, is that you need to measure about every inch or so, not every few inches. the gap between points that you measure isnt linear in most places.
Yeah I have been looking at that. Have not had time in the hangar this week to do much so no new work here. The idea is to get a cut that is very close to the cowl surface, then user paperclips or similar to make the final 3/8 - 1/2 inch cut.
__________________
Greg Hughes - Van's Aircraft
Van's web site | Instagram | Facebook
Opinions, information and comments are my own unless stated otherwise. They do not necessarily represent the direction/opinions of my employer.

Building RV-8A since Sept 2014
Dual AFS 5600, Avidyne IFD 440, Whirlwind 74RV, Superior XP IO-360
VAF build thread - Flickr photo album - Project Facebook page
Aurora, OR (EAA Chapter 105)

Reply With Quote