I previously had a dual Non Touch G3X which was wired so I received an aural beep alert as I approach assigned altitude*at 1000'*+/- and then again at 200' +/- and would also alert when passing outside 200'*+/- As described on page 78 of the pilots guide for the G3X Touch (same for non touch).* I received these alerts on the non touch but I do not receive these alerts on the touch.
I have a GMA 240 and it was essentially plug and play to the touch (P4X02/P3701) from the non touch. I have checked to make sure the wiring matches the attached diagram and that the pins/wires are not broken or disconnected at the J1 of the 240 at pins 31, 32 and the P4X02 of the G3X at pins 1, 18. Wiring and connections are good.* Also I checked the sound configuration page on the G3X so that the Alert Source is configured to PFD only and the Alert Output is set to Mono only.
I get all the audio alerts (I think generated by the 650xi) such as traffic, terrain, 500', obstacles, minimums, just no aural tones at the altitudes.
I spoke with g3xperts a few times and they suggested checking the Sound configuration*then next time they thought that my G3X may not have been connected to the GMA240. I have verified all is correctly set but still no aural alert tones.
Can you think of anything further that I may check or configure.
I have a GMA 240 and it was essentially plug and play to the touch (P4X02/P3701) from the non touch. I have checked to make sure the wiring matches the attached diagram and that the pins/wires are not broken or disconnected at the J1 of the 240 at pins 31, 32 and the P4X02 of the G3X at pins 1, 18. Wiring and connections are good.* Also I checked the sound configuration page on the G3X so that the Alert Source is configured to PFD only and the Alert Output is set to Mono only.
I get all the audio alerts (I think generated by the 650xi) such as traffic, terrain, 500', obstacles, minimums, just no aural tones at the altitudes.
I spoke with g3xperts a few times and they suggested checking the Sound configuration*then next time they thought that my G3X may not have been connected to the GMA240. I have verified all is correctly set but still no aural alert tones.
Can you think of anything further that I may check or configure.