dick seiders
Well Known Member
1. 2902 step 3 plans call for riveting nutplate only at top hole. Am now on 2903 step 2 . Looking ahead can find no instruction to add 2nd rivet to nutplate.
2. Also dimpled 6 #30 holes on bottom of 1201A. Plan calls for flush on top which is contrary to the dimples I put on the F1201B shelf and the F1257 rudder support channels. I am unable to find dimple position instructions for these. I suppose I need to reverse these dimples but want to be certain before doing so. Lastly I presume these positions take CS$-4 rivets, but can find no plan view of those either.
Would appreciate any clarification on these issues from you folks who are ahead of this stage. Thanks
Dick RV6A and lovimg it till the 12 is ready
2. Also dimpled 6 #30 holes on bottom of 1201A. Plan calls for flush on top which is contrary to the dimples I put on the F1201B shelf and the F1257 rudder support channels. I am unable to find dimple position instructions for these. I suppose I need to reverse these dimples but want to be certain before doing so. Lastly I presume these positions take CS$-4 rivets, but can find no plan view of those either.
Would appreciate any clarification on these issues from you folks who are ahead of this stage. Thanks
Dick RV6A and lovimg it till the 12 is ready