View Single Post
  #2  
Old 04-14-2020, 06:06 PM
pazmanyflyer's Avatar
pazmanyflyer pazmanyflyer is online now
 
Join Date: Jul 2007
Location: Litchfield Park, AZ
Posts: 1,059
Default

Quote:
Originally Posted by Coaltowngarage View Post
Building this early 90s kit. Was passed around a bit over the years. As you can imagine...theres stuff missing. On my plans, it calls for an aluminum angle 1 inch by 1 1/4 by 1/8 that runs from the lower corner of the firewall to the wing spar bulkhead 604. I see on vans website they do not carry a 1 x 1.25 x. 125 angle. I appears that vans no longer offers this size angle. Does anyone know of an acceptable replacement material for this section? It appears to be the only place on the plane that this dimension material is called for.
Order the AA6-125X1 1/2X2X10 (10" or 30") and fabricate the required piece. This is a structural piece with a radius at the interior vertex. Don't sub it with a piece from the local metal shop.
https://shop.vansaircraft.com/cgi-bi...&product=angle
__________________
Carlos in Arizona
EAA Chapter 538 www.chapters.eaa.org/eaa538
Wittman Tailwind W8 N53CH (built & sold)
Pazmany PL-1 N2029 (bought & sold)
RV7 - N537TC (reserved & building)
Emp, Wings & Fuse done - working on FWF

"The air is an extremely dangerous, jealous and exacting mistress. Once under the spell most lovers are faithful to the end, which is not always old age." - Winston Churchill
Reply With Quote