Originally Posted by PilotjohnS
Also, why is the plate touching this? Is the clearance hole not big enough, or is it off center?
If it is just junk building up in the hole, I again go back to my antiseize to fill up that spot. JMHO YMMV
I checked the clearance and it was good. I also checked the construction manual and hole is suppose to be drilled to 3/8"...it looks like it was (I'm not the builder).
I think anti-seize sounds like the ticket, and tef gel looks promising...I'll just stay away from jam nut portion of thread for proper torque.
2019-2021 Dues Paid
Last edited by avrojockey : 05-17-2020 at 01:36 PM.