View Single Post
  #6  
Old 04-13-2010, 12:51 PM
paul330 paul330 is offline
 
Join Date: Feb 2007
Location: Mpumalanga, South Africa
Posts: 1,065
Question Couple more questions

Well, it took me 3 hours to drill out the offending parts but it's done with no damage and clecoed back in the right place. Annoying but no more......

However, a couple of extra questions have been thrown up as I have examined the parts:

- page 26-5 step 6 states to dimple most of the holes in the F-1018 outboard ribs. It looks as if the webs of the F-1015A ribs should also be dimpled but I cannot find any mention of it. I see no reason to wait until after match drilling the side skin as dimpling then would be very difficult. Any pointers?

- there is also a #30 hole in the F-1004K Side Plate that looks like it should be match drilled through the F-1004C Bulkhead but page 28-9 step 2 states only to drill the #40 holes.

It's been a frustrating couple of days and I want to get it right this time
__________________
Paul
Mercy Air, White River FAWV
RV-10 ZU-IIZ - "Zeus"
Building Bearhawk Bravo - RV-18 not available
2019 Donation Made
Reply With Quote