While waiting for the arrival of my Garmin servos, I thought I would amuse myself and take a few photos of some of the things I'm doing that might be helpful to others. Here is the pitch servo mounting setup from the Garmin mount kit:
Here is where I mounted my GPS antenna for the new GDL-39R ADS-B receiver, which I'm mounting in the back tailcone.
Here is where I mounted my GTX-23ES, at the bottom of the radio stack:
And finally here is the Lexan mockup panel that I am using to locate the cutouts for the radios, etc.:
The Lexan mockup is working out very well so far; once I have everything cut out and drilled, including the location of the mounting screws, I'll transfer it to the .063 aluminum sheet. I used a 1/16" Lexan sheet that I got from Spruce for this.
Here is where I mounted my GPS antenna for the new GDL-39R ADS-B receiver, which I'm mounting in the back tailcone.
Here is where I mounted my GTX-23ES, at the bottom of the radio stack:
And finally here is the Lexan mockup panel that I am using to locate the cutouts for the radios, etc.:
The Lexan mockup is working out very well so far; once I have everything cut out and drilled, including the location of the mounting screws, I'll transfer it to the .063 aluminum sheet. I used a 1/16" Lexan sheet that I got from Spruce for this.