View Single Post
  #3  
Old 09-07-2021, 09:33 AM
squeakersc063 squeakersc063 is offline
 
Join Date: Jul 2020
Location: Las Vegas
Posts: 10
Default

Quote:
Originally Posted by RV701775 View Post
How important is it that the elevator close out tabs be bent exatly 1/32 over the bend line. As you can see in the pictures, it is closer to 1/16 in on the trailing edge. When looked at from the bottom of the skin, there is also a bit or waviness. Is this a redo? The top one is not much better.

https://eaabuilderslog.org/?blprojen...&listcat=&sid=
I've seen some builder logs where dudes just cut that off and fabricate a rib to close it out. The closeout doesn't touch the trim tab so I'm happy how mine came out.
Reply With Quote