What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Dynon Servo wiring question

p51dplt

Well Known Member
Can someone help shed some light on why the servo wiring schematic shows two female D-Sub connectors? I'm not following why or what there would be two for.

Thanks.
 
Right at the servo you put a female connector and male connector to make a line disconnect before the harness for when you need to remove the servo you just disconnect the Sub Ds and leave the harness, if that is what you are referring to.
 
The harness itself has two female connectors. Each end connects to a male DB9. One on the servo, one to the network hub/EFIS.
 
Brant,
The connector at the servo end is there just so you can maintain the servo in case you ever need to remove it. If you want to direct connect the wires you can.
 
Back
Top