VansAirForceForums  
Home > VansAirForceForums

-POSTING RULES
-Advertise in here!
- Today's Posts | Insert Pics

Keep VAF Going
Donate methods

Point your
camera app here
to donate fast.


Go Back   VAF Forums > Search Forums
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Showing results 1 to 39 of 39
Search took 0.00 seconds.
Search: Posts Made By: GOFT
Forum: RV-14 12-27-2021, 08:56 PM
Replies: 6
Views: 583
Posted By GOFT
Butt to vertex 37"

This is getting personal:)
Forum: RV-14 12-26-2021, 06:54 PM
Replies: 6
Views: 583
Posted By GOFT
Headroom RV 14

6'5". With the seat in the most aft position for max leg room (thus most "upright" back rest position); fairly low seat cushion: leaves two fingers from vertex to canopy.
Forum: RV-14 12-26-2021, 06:46 PM
Replies: 12
Views: 1,784
Posted By GOFT
Back fire

What is not to like about that back fire in the pattern pulling the power back from say 18 to 10" in order to slow down?:)
If I keep the mixture lean for the descent and pull back the power in the...
Forum: RV General Discussion/News 12-17-2021, 01:43 PM
Replies: 13
Views: 1,424
Posted By GOFT
Rudder trim

Yep, you are correct. Useful bits and pieces left over from the build. It is a wedge after all.
Filled up the holes and taped a 6" piece onto the rudder with double sided tape.
To streamline the FWD...
Forum: RV General Discussion/News 12-13-2021, 11:18 PM
Replies: 13
Views: 1,424
Posted By GOFT
Rudder tab

Elevator trailing edge wedge. 6" piece.
https://store.vansaircraft.com/aex-wedge-11-9x20-elevator-edge-wedge-aex-wedge-11-9x20.html
Forum: RV Ongoing Maintenance Issues 12-10-2021, 04:21 PM
Replies: 17
Views: 3,688
Posted By GOFT
Alternative to Mouse Milk, exhaust joints?

Is Permatex copper based anti-seize of any use? Temperature rated to 1800dF.
Should one loosen and exercise or disassemble the exhaust joints yearly?
Thanx
Forum: RV-14 12-05-2021, 03:36 PM
Replies: 7
Views: 1,127
Posted By GOFT
Condition inspection list

I sent you a private message to get your email.
Forum: RV-14 12-03-2021, 04:13 PM
Replies: 7
Views: 1,127
Posted By GOFT
Condition inspection

I can send you one I made for the 14A. Might need to chop and trim as too bulky.
Forum: RV Building Tips/Techniques 10-13-2021, 03:02 PM
Replies: 30
Views: 4,521
Posted By GOFT
Smile Wing root gascolators RV 14, why bother?

Each quick drain Andair GAS375 aluminum gascolators has a 49 cm2, 70 micron stainless steel woven mesh filter coated with PTFE. Suppose to prevent water to pass through the wire screen by keeping the...
Forum: RV-14 08-13-2021, 05:59 PM
Replies: 5
Views: 1,146
Posted By GOFT
Firewall sealant

Used Proseal tank sealant. Did not know any better. Hopefully I shall be back on the ground in one piece before the Proseal fails and allows smoke and flames into the cockpit.

Related topic....
Forum: RV General Discussion/News 08-07-2021, 03:57 PM
Replies: 54
Views: 6,032
Posted By GOFT
14-21 psi is the Input pressure required for this...

14-21 psi is the Input pressure required for this compressor to fill your tank.
Forum: RV-14 06-27-2021, 06:22 PM
Replies: 6
Views: 4,196
Posted By GOFT
Footwell skin rivets RV 14

Cherrymax rivets worked well for the "middle section" under the lower longeron.
Neat, reproducible and pretty strong.
Forum: RV General Discussion/News 06-20-2021, 11:29 PM
Replies: 29
Views: 7,170
Posted By GOFT
Cruising at 9500, summer is here

Northbound in the Kananaskis area towards Banf, Alberta
Forum: RV-14 06-14-2021, 10:33 PM
Replies: 12
Views: 2,160
Posted By GOFT
Was pretty tight, but doable. Used home made dollies

Door width: 84 inches, doors swinging outwards. Door height: 79 inches.
Forum: RV Ongoing Maintenance Issues 06-04-2021, 12:26 AM
Replies: 3
Views: 1,262
Posted By GOFT
Rain

Thanks for all the responses.
Sounds like not any harm done to filter or engine.
Shall dress out the prop leading edges a bit to make it airworthy. Sorry, I meant pretty.:)
Forum: RV Ongoing Maintenance Issues 05-28-2021, 06:36 PM
Replies: 3
Views: 1,262
Posted By GOFT
Engine intake air filter and rain

Was caught in a downpour some days ago.
Throttled back, pulled the prop coarse and turned for home to prevent too much damage to prop or risk a leak into the tip-up canopy.

K+N E-3450 filter.
I...
Forum: Electronic Ignition Systems 01-13-2021, 03:44 PM
Replies: 36
Views: 8,044
Posted By GOFT
Wrong mag

Just to clarify, GOFT never had trouble with his P mags.
He was just clueless on how the mag switch grounds. Cerebral problem.:)
The OP is the one with the mechanical problem.
Forum: Electronic Ignition Systems 01-12-2021, 09:59 PM
Replies: 36
Views: 8,044
Posted By GOFT
Nope, you are correct. I was wrong. Selecting...

Nope, you are correct. I was wrong. Selecting Left, grounds the Right and runs the Left. Thanks for pointing it...
Forum: Propellers 01-10-2021, 10:48 PM
Replies: 43
Views: 28,863
Posted By GOFT
[QUOTE=gmcjetpilot;172309]Not all equip is the...

[QUOTE=gmcjetpilot;172309]Not all equip is the same and more over not all technicians and techniques are the same. The test should be done under power with the blades off the stop (constant speed...
Forum: Electronic Ignition Systems 01-10-2021, 07:53 PM
Replies: 36
Views: 8,044
Posted By GOFT
Thanks for the responses. I'll try to answer all...

Thanks for the responses. I'll try to answer all the questions. First, I went to do a run up one day and when I did the mag check I got a 200 RPM increase when I shut the E-MAG off and the engine...
Forum: RV-14 01-09-2021, 05:16 PM
Replies: 21
Views: 6,413
Posted By GOFT
Page 7 of 12 points to both the exit placard and...

Page 7 of 12 points to both the exit placard and the cargo restraint.
Document MDRA C20E MFTW 20150401
Useful checklist before you square off with the inspector, no surprises.
Forum: RV-14 01-09-2021, 11:56 AM
Replies: 21
Views: 6,413
Posted By GOFT
"Cargo net"

Any means to secure luggage in the baggage area.
Straps, bungee, whatever.
I used a square of old fishing net and 6 carabiners secured to the fuselage.
Forum: RV-14 01-09-2021, 09:13 AM
Replies: 21
Views: 6,413
Posted By GOFT
Placards

"Exit" is all you need for your latch.
I did not see a requirement for stepwise or progressive instructions.
You could label the white T-handle on the panel: "to exit, pull below 10 feet and 50 kts...
Forum: RV-14 12-14-2020, 11:16 PM
Replies: 67
Views: 24,296
Posted By GOFT
Endplates

Thanks for the update.
Forum: RV-14 12-09-2020, 06:25 PM
Replies: 67
Views: 24,296
Posted By GOFT
Muff OD is 2-3/4". Thanks for the lead to Rick...

Muff OD is 2-3/4".
Thanks for the lead to Rick Robbins.
Forum: RV-14 12-08-2020, 08:20 PM
Replies: 67
Views: 24,296
Posted By GOFT
Exhaust RV 14 Vans stock

1.75" OD.
Scott come in, Scott come in. :)
Forum: RV-14 12-07-2020, 08:46 PM
Replies: 67
Views: 24,296
Posted By GOFT
RV 14 heat muffs

Timely!
I found that the heat muffs keeps loosening after a few hours of flying. Tightening the "hose" clamps deformed the very flimsy/fragile endplates.

Just replacing the endplates are not an...
Forum: Traditional Aircraft Engines 09-12-2020, 07:30 PM
Replies: 28
Views: 7,820
Posted By GOFT
Break in new IO 390

RV 14, dual P mags, Hartzell prop. 16 hours thus far.

First 5 hours mostly at 5 000' MSL.
WOT, 2490 RPM, leaned to best power as soon as leveled off (used the take off EGT to lean to, so roughly...
Forum: RV-14 08-22-2020, 02:46 PM
Replies: 2
Views: 1,907
Posted By GOFT
Spring

Not used in the RV 14 canopy
Forum: Traditional Aircraft Engines 07-08-2020, 02:53 PM
Replies: 28
Views: 7,820
Posted By GOFT
First flight power settings

Blue skies for your first flight!
I PM'ed you power setting suggestions I got from Lycoming for first flight.
75%: yes we heard so, but translate that to RPM, Manifold pressure, MSL, OAT and humidity.
Forum: RV General Discussion/News 05-30-2020, 11:10 AM
Replies: 46
Views: 14,210
Posted By GOFT
Comparison chart

Paul, how is the speed ratio calculated? Thanks
Forum: RV-14 04-22-2020, 08:41 PM
Replies: 13
Views: 6,246
Posted By GOFT
Pin out in the wing

Not sure if this is helpful

Magnetometer GMU 22 Left wing inboard inspection plate access
 Pin out CPU connector:
o 1 solid green shielded 12h00
o 2 white and black shielded 5 to
o 3 solid green...
Forum: RV General Discussion/News 04-18-2020, 09:46 PM
Replies: 8
Views: 1,361
Posted By GOFT
Mouse Milk

Dan H
Good evening. What do you use on these swivel joints?
Forum: Traditional Aircraft Engines 04-12-2020, 07:11 PM
Replies: 14
Views: 2,430
Posted By GOFT
Mix too rich?

IO-390. Which Fuel servo?
RV 14 with a FM-150. Mixture-throttle interconnect bar/link on top of the servo. Shorten the link to lean the mixture.
In my experience of ONE :-)
Loosen the lock...
Forum: RV-14 04-11-2020, 10:35 AM
Replies: 22
Views: 5,168
Posted By GOFT
Not a single thing achieved by low idle.

Float plane or amphib.
The lower your RPM, the more time to jump out and dock not risking ramming your floats into some riverbank or rocks. (SuperCub O-360 carb, slicks, 470 idle RPM.) Granted only...
Forum: Traditional Aircraft Engines 04-06-2020, 03:58 PM
Replies: 11
Views: 2,020
Posted By GOFT
Fuel flow

RV-14A. Andair electric pump with wing-root mounted Andair gascolator (70 micron mesh). 1.5 gallon fuel in the the tank. Fuel line disconnected at the FM-150 fuel servo and tied up on that...
Forum: RV-14 03-07-2020, 12:14 PM
Replies: 0
Views: 1,449
Posted By GOFT
Climb attitude RV 14, degrees nose up

Ball park figures?
Vy 95 kts Degrees nose up 12.5
Vx 70 kts Degrees nose up 15 ?
Thanks
Forum: RV-14 03-01-2020, 09:17 PM
Replies: 19
Views: 6,589
Posted By GOFT
Spark plug thread drift

Denso IKH 27 long reach, the correct one
Denso IK 27 is a short reach plug
Sourced the former at sparkplug.com
Forum: RV-14 02-05-2020, 11:19 PM
Replies: 2
Views: 1,982
Posted By GOFT
G3X numbers

Sent you a pm with some numbers taken from Steevo's blog.
Showing results 1 to 39 of 39

 
Forum Jump

All times are GMT -6. The time now is 03:24 AM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.