![]() |
I have been using a Chapman tool kit since before I built the airplane.
![]() http://www.all-spec.com/products/432...FeeDQgodcUUAPg Screwdriver, allen bits, and 1/4" square drive adapter. |
General makes a little clicker ratchet that isn't too elegant, but is the shortest one I've seen. It comes with a phillips on one side, flip it to use the straight blade on the other side. Most guys grind off the straight blade so you can use a finger or a prybar on top. Like $6.
|
Picked one up at Sears just a couple of months ago. Craftsman on the handle and it was only about $6 or $8.
|
Randy Thorne ----Sport Air Serv here on VAF, showed me these a few years ago, I bought two, one for the plane and one for the shop.
Even given them as gifts to a few folks. TOTALLY happy with the tool, would recommend them to all RVers. Strong well built, fine toothed ratchet works well in tight quarters. Husky 8-Piece Bit Ratchet Set Model # 64723T ![]() |
Quote:
You can cut a apex bit in half and really take advantage of the slim size for those tight spots. |
vim hbr5
The husky tool is made by Vim Tools P/N HBR5 Check Amazon.
http://www.amazon.com/s/ref=nb_sb_no...rds=vim%20hbr5 |
Quote:
Made in USA even:D http://www.vimtools.com/home.asp |
Thanks
Quote:
|
I have the Sears equivalent - I don't use it often but there are times when it is the only tool that works :)
http://www.sears.com/shc/s/p_10153_1..._tnt=39869:4:0 |
I don't always...
Quote:
![]() |
| All times are GMT -6. The time now is 07:56 AM. |