VAF Forums

VAF Forums (https://vansairforce.net/community/index.php)
-   RV-12/RV-12iS (https://vansairforce.net/community/forumdisplay.php?f=73)
-   -   Condition Inspection Item - Radiator Hose Abrasion (https://vansairforce.net/community/showthread.php?t=78955)

db8 11-16-2011 09:04 AM

Yes. I have used the rescue tape around scat tubing with tie wraps and wire bundles with tie wraps . I decided not to use it on the engine mount because the tie wraps are generally tighter there and might have more of a tendancy to cut into the tape (though I don't know). It sounds like guys have been using it with no problems. I do know the clear tubing so far has held up very well and is very tough. Dave

David Paule 11-16-2011 09:09 AM

For the idea of a soft layer around the engine mount tube, just be sure that your material can withstand the heat. Likewise, if you're using a dab of silicone, use the high-temp kind.

I used some non-heat-resistant spiral wrap around some wires on a different plane, and the stuff melted. Unfortunately the melted and cooled material was difficult to remove.

The max heat usually occurs sometime after shut-down.

Dave

TS Flightlines 11-16-2011 10:00 AM

maybe-
 
for those that want to wrap tape around the mount---use Firesleeve tape. High temp, self adhesive, and with layers, should protect the mount and the hose.

jarhead 11-17-2011 11:04 PM

Quote:

Originally Posted by MartySantic (Post 596282)
Some type of clamp will be required to hold the hose in position. Ideas?


There's three MS21919-series ideas within your photo...
I'm one of those people here on VAF that says the bare ziptie on your engine mount needs to go, too.


All times are GMT -6. The time now is 08:16 AM.