![]() |
Landing Light out
N12HR was built in about 1991. The landing light is out. It appears to be rectangular auto light. It has the plastic cover on the right wing. I can't get the plastic cover off. It acts like it is glued on. Any ideas of the bulb type or how to get the cover off. The screws have been removed. Thanks
|
A picture is probably the only way to figure this out. I sent you a private message.
|
Sounds like a Duckworth Halogen Landing light to me.
They come with 55 Watt bulbs but have I changed mine out with 100 Watt bulbs as they burned out. (Sylvania 64153 H3-Type 100 Watt or equivalent) The two of them will light up the runway from 400 feet. Although I keep thinking I would like to replace them with LED's, these work really well with the 100 Watt bulbs. There should be six screws that hold the cover in place, three on top and three on the bottom. You push the cover in, turn it sideways, and pull it out. The reflector should be held in with two screws and should come right out. OR If you can remove the wingtip, you might be able to get access that way. The bulbs are just a few dollars each. I would buy two and replace them both. |
I just installed the ductworks kits. If that's what you've got, the lenses have a sticky foam gasket sandwiched in there. I suppose it's also possible that somebody glued them in with RTV or something instead of using the gasket.
If you've got all the visible screws removed, there's nothing else holding it in there. If you break it getting it apart, all is not lost. Duckworks sells the lens blanks for $15. |
Quote:
|
Quote:
That was a couple of years ago and I suspect LED's have come a long way since then. If any of the LED vendors read this, please email me, I would very much like to do this test at our un-lit country strip. [bill (at) repucci (dot) com] |
Found an even cheaper replacement 100 watt H3 bulb. Regular price $5.99 and currently on sale for just $2.99 each
https://shop.advanceautoparts.com/p/...909/11045316-P |
Here are photos he texted me of the light he is talking about:
![]() ![]() |
If I had those reflectors I'd install a set of H-4 55watt 6000k Pure White HID lamp systems that fit those reflectors. They're light and they're bright and they're cheap. Something like this :
https://www.ebay.com/itm/55W-HID-Xen....c100005.m1851 |
Thanks for the help! I will look at those.
|
| All times are GMT -6. The time now is 03:25 AM. |