Aileron Trim with VP-100 & AFS-4500
 

When I wired my RV-9A about 10 years ago I wired electric elevator trim to Vertical Power VP-100 and stick top hat switch. I also wired it to display trim position on both VP-100 display and AFS-4500 display. Now I?m adding electric aileron trim. I unfortunately can?t find my diagram on that wiring on how I did it. I seem to remember resistors involved or something a little more complex than just parallel signal feed. Anyone know how to do this? I?ve done various searches here and on AFS site with no luck. Old technology and searches only come up with newer VP-X stuff. Thanks.

Disregard. Fixed. Just connected to same signal but needed to rescale in EFIs.

Mark, Let me know if you need any VP-100 info. Marc