![]() |
Stall spin margin
Did something today that got me wondering how close I was to the edge.
First, 74 hours in my -8 and haven't explored much of the edge in a controlled situation. I try to do a bit each time up but haven't explored this situation yet. I fly downwind to final as a tight continuous turn. I have AOA and know where it's at in the pattern. So today I'm on final, 80k, have 3 bars green on AOA, and overshot centerline. Without even thinking (!) I found myself pulling it around and uncoordinated. I had airspeed, pitched down and plenty of reserve on AOA. It felt comfortable. Seemed well within what the -8 could do without concern but once I realized what I did it got me wondering how close I was. I'll go out next time and duplicate the scenario at altitude. In the meantime should I increase my insurance coverage?:eek: |
Several things:
* In gusty conditions, there are formulas to tell you how much to increase your airspeed for safety. There are no formulas telling you how much to change your AOA based on reported winds and gusts. Do NOT use your still air AOA in gusty conditions -- that's the same as flying with no additional airspeed for gust compensation; * Do some approaches in which you deliberately overshoot centerline and gently, slowly come back to where you want to be. This will train your inner brain that an overshoot is not a catastrophe that requires immediate, drastic (and potentially dangerous) maneuvering to get back to the comfortable center of the runway. Do those practice overshoots at 500 feet or so a few times before you get lower; * Just like you don't chase airspeed on final, don't chase AOA. There was a NASA Technical Note (TN D-6210, March, 1971) in which they found that flying AOA on approach didn't work very well in a GA airplane as primary guidance; * In my RV-8, it's so maneuverable that it's tempting to land out of every approach, and that's a bad habit I've developed, reinforced by lots of good landings from bad approaches. I'm now working on good landings from good approaches; * Find a really good stick and rudder instructor and go practice some of these situations with that instructor, even if it's not in the RV-8. Don't take my word for it, get somebody to watch you at work. After all, you don't learn to swim by reading a book. (Standard disclaimer applies -- don't try what I recommend without trying it first with a really good CFI). You sound like you've got a good attitude towards safety! Be careful, practice, and don't push it. Years ago, there was a poster that showed a DC-8 being lifted out of the water and being placed on a barge. The caption was, "No approach is so bad that it can't be salvaged." |
Quote:
Id reccomend going up high and practice accelerated stalls in the landing configuration. You will find that the -8 will turn remarkably tight and if it does unhook, the stall is benign - provided the ball stays centered! Let the ball out of the cage and all bets are off. Id also recommend doing sustained 1g stalls and practice keeping the wings level with rudder only. In other words, go nice and high, stall the airplane with the stick locked firmly back and dance ONLY on the rudder pedals to keep the wings level. Its great training for the correct automatic response then things go sideways. Once you have that down pat, try freezing the rudder and working the ailerons to keep it level - but be prepared for a nearly instant wing drop and departure. Its a great (and dramatic) way to demonstate how powerful the rudder is in a stall, and also how incorrect the ailerons are. |
Blain,
Foremost--you did a great job debriefing yourself! And, we learn by making mistakes, either our own or observing other's. Eventually, most of us learn that not all patterns/approaches can be salvaged...which is why the first rule is, if in doubt go around. We definitely want to avoid a "skidding" departure at low altitude, because the airplane will snap underneath with very little aerodynamic warning if you stall it: https://youtu.be/h5OFuQaYs1o. On the other hand, if you stall in an "inside slip" on base (a technique that many folks use to dissipate excess energy in the base turn), the post-stall charteristics are different, and the airplane provides significant aerodynamic warning of impending departure post-stall in the form of uncommanded roll (which is just a fancy way of saying you have to force it to depart): https://youtu.be/uMEVEZMUDXY Ed is spot on regarding chasing either airspeed or AoA in the pattern--here's more examples of "patterns gone wrong:". https://youtu.be/BCQF8B49tgw. A "slightly fast" AoA is generally appropriate for gusty conditions, but it does take some flight test to figure out what constitutes "slightly fast" with your system. One technique to do this is to establish a normal ONSPEED/Vref condition, note the IAS, add the appropriate gust factor to the IAS, then note the AoA indication/sound to see or hear "slightly fast" in your plane. The root cause of most of these errors is where you start your base turn. If you take a look in the transition training manual beginning on page 226, you'll find quite a bit of info that you might find helpful: https://drive.google.com/open?id=0B8...mJNRmRfcGR3dm8. Discussion on pp 231-232 specifically addresses how to plan the base turn point for the type of pattern you are flying. The bottom line is that if you keep the ball in your cross-check, i.e., keep it coordinated, you'll have options to either fix your energy problems or safely go around. Good post post/topic for discussion. Fly safe, Vac |
"Uncoordinated" sounds like the ante-room that leads into "cross-controlled" - a stall from which there is no recovery on short final. You are right to be concerned about what happened, and good on you for recognizing it and chiding yourself to do something pro-active about it. We would all be well-served to have that attitude. :)
|
My close in short turn to final is at 65-70 KIAS.
Keep it coordinated and at 1 G, it is safe. |
Quote:
|
Since you have AOA it is giving you a realtime reference of how much margin you have above stall. In talking with several people who have added AOA one of the surprising things is that it caused them to fly a more conservative pattern as they discovered how close they were pushing things when trying to tighten up a turn. They had no idea using airspeed alone.
I would do some work at altitude scanning both AOA and airspeed simulating varies turn rates in the landing configuration. Each AOA is calibrated to that airframe so you need to explore the limits yourself. Everyone should explore both 1G and accelerated stalls at a safe altitude. Watch your AOA as you do this and pick a personal reference AOA you are not going to exceed in the pattern. Set your aural warning just below that point. G |
First thing you need to do is complete phase I flight testing. You obviously haven't done that. Phase I flight testing consists of testing the aircraft throughout its normal range of speeds, throughout all weights and C/G ranges and all maneuvers to be executed.
The aircraft must NOT be signed off into phase II until you have explored the entire envelope. |
Quote:
Quote:
And 2nd with the ports on the left wing should a greater margin be made on right patterns? Quote:
|
| All times are GMT -6. The time now is 12:47 PM. |