VAF Forums

VAF Forums (https://vansairforce.net/community/index.php)
-   RV-8/8A (https://vansairforce.net/community/forumdisplay.php?f=6)
-   -   Howdy (https://vansairforce.net/community/showthread.php?t=102126)

KMinor 07-21-2013 07:44 PM

I, for one, really like your avatar! And I'm a little jealous. I never got the welcome from Mike S. I found most answers I needed on here by searching after I joined up and didn't write any posts for a long time. I guess I kind of just slipped through.

Mike S 07-21-2013 08:04 PM

Welcome to VAF!
 
Quote:

Originally Posted by KMinor (Post 790249)
I And I'm a little jealous. I never got the welcome from Mike S.

Kevin, A great big belated to VAF for you.

Sorry, I have failed at my self appointed job---:(

KMinor 07-21-2013 08:18 PM

Hey thanks!!
 
You didn't fail, I was just really sneaky!

Roarks 07-23-2013 12:05 AM

Thanks for the kind reception:)

So my first question... dimple die for a squeezer, on a flat c-sink #3 (edit: might be a #4 remember now will check in the morning) rivet in two sheets of .032"... what's the procedure? Anyone care to explain or have a good link? I'm trying to put together my Vans Toolbox practice kit... and want to get it right. Even my A&P guys I know weren't really explaining, they said they had a rivet set for that? I tried a few searches and have come up even more confused.

Thanks!

Roarks 08-14-2013 10:04 AM

Okay... now that I have been playing with my rivet gun a bit...
Where do I find out about a sheetmetal workshop or something in AZ? Apparently this is something I have no natural talent for.

Mike S 08-14-2013 10:08 AM

How close to Chandler are you???

There are a couple RV guys up there, maybe you could get some "one-on-one" training if you brought the beer;)

Roarks 08-15-2013 02:48 PM

About a 45min drive, but I'm at KCHD just about every weekend over at Quantum

Mike S 08-15-2013 03:25 PM

Roark, sent you a PM.


All times are GMT -6. The time now is 08:38 AM.