VAF Forums

VAF Forums (https://vansairforce.net/community/index.php)
-   RV General Discussion/News (https://vansairforce.net/community/forumdisplay.php?f=2)
-   -   a couple printed ideas (https://vansairforce.net/community/showthread.php?t=147771)

Steve Melton 10-14-2019 04:29 PM

Clarity Aloft
 
on the way back to the owner after 4 days with a couple free control mounts.

thx for the use of your headset for a pattern. you will like the fit.

so far we have:
Bose AHX
Bose A20
Clarity Aloft










Sam Staton 10-14-2019 05:37 PM

You’re welcome. Looks good.

Steve Melton 10-14-2019 09:42 PM

Spark Plug Lead Baffle Seal
 
Drill Pattern


flysrv10 10-15-2019 07:17 AM

Steve, looking to buy an aileron gust luck for RV10. No response from rvplastics. Three messages on rvplastics website looking to do the same. Thanks.

Steve Melton 10-15-2019 07:22 AM

Quote:

Originally Posted by flysrv10 (Post 1379877)
Steve, looking to buy an aileron gust luck for RV10. No response from rvplastics. Three messages on rvplastics website looking to do the same. Thanks.

I don't think Amanda is notified of questions on her website for product comments. Just send her an email.

flysrv10 10-15-2019 07:25 AM

Have sent her direct email too. perhaps I have the wrong email.

Steve Melton 10-15-2019 07:32 AM

Quote:

Originally Posted by flysrv10 (Post 1379880)
Have sent her direct email too. perhaps I have the wrong email.

I'll check with her. One of the nice aspects of working these plastic parts with Amanda is that we communicate more than we would otherwise.

Steve Melton 10-15-2019 10:36 PM

ABS and Carbon fiber filament
 
a nice tactile feel material. stiff, lightweight, and beautiful. relatively quick to print.




Steve Melton 10-16-2019 05:21 PM

ABS and fiberglass filament
 
similar feel to carbon but not the same. lightweight and stiff.


Steve Melton 10-20-2019 08:21 PM

Spark Plug Lead Baffle Seal
 
checked the torque on the copilot side and it was OK. it had one re-torque since installation. re-torqued the pilot side for the first time, it had lost some torque since the install. I'll check the torque again at the next oil change in 50 hrs.



All times are GMT -6. The time now is 07:42 AM.