VAF Forums

VAF Forums (https://vansairforce.net/community/index.php)
-   RV General Discussion/News (https://vansairforce.net/community/forumdisplay.php?f=2)
-   -   Rudder TE waviness (https://vansairforce.net/community/showthread.php?t=189363)

stigaro 11-26-2020 08:20 AM

Rudder TE waviness
 
1 Attachment(s)
I completed the trailing edge for my -14A rudder yesterday. I used the squeezer with a combination flat and angled die. Turned out great. HOWEVER, when I rolled the edge of one of my skins, I think I had too much pressure on the rolling tool and the edge ended up with a little "waviness" to it. I was hoping that after riveting, that it might flatten it, but sadly it did not. So while my TE is straight, it has a slight waviness (maybe 1/32"). Is there anything that can be done to flatten this out?


All times are GMT -6. The time now is 08:26 PM.