VAF Forums

VAF Forums (https://vansairforce.net/community/index.php)
-   Autopilots (https://vansairforce.net/community/forumdisplay.php?f=37)
-   -   Dynon Servo wiring question (https://vansairforce.net/community/showthread.php?t=138134)

p51dplt 05-23-2016 10:17 AM

Dynon Servo wiring question
 
Can someone help shed some light on why the servo wiring schematic shows two female D-Sub connectors? I'm not following why or what there would be two for.

Thanks.

krw5927 05-23-2016 12:34 PM

Unsure what schematic you're looking at. Got a photo or a link?

dynonsupport 05-23-2016 12:34 PM

Brant,
We have a lot of wiring diagrams. Where are you seeing this?

Ron B. 05-23-2016 12:39 PM

Right at the servo you put a female connector and male connector to make a line disconnect before the harness for when you need to remove the servo you just disconnect the Sub Ds and leave the harness, if that is what you are referring to.

Raymo 05-23-2016 12:51 PM

The harness itself has two female connectors. Each end connects to a male DB9. One on the servo, one to the network hub/EFIS.

p51dplt 05-23-2016 04:36 PM

Quote:

Originally Posted by dynonsupport (Post 1081512)
Brant,
We have a lot of wiring diagrams. Where are you seeing this?

Figure 100 on page 10-10 of the SV installation manual.

dynonsupport 05-23-2016 05:10 PM

Brant,
The connector at the servo end is there just so you can maintain the servo in case you ever need to remove it. If you want to direct connect the wires you can.


All times are GMT -6. The time now is 11:19 PM.