rv3flier
Well Known Member
After having removed and reinstalled my fuel tank the calibration was lost. The builder recorded a table of mV values for calibration at 2 gallon intervals for a total of 9 readings reaching 14.8 gallons. Is there a way to re-enter these values into the Dynon 180 without having to drain and refill as was done originally?
Example: 1st reading empty: mV = 2731
2nd reading 2 gallons: mV = 2655
and so on to 9th reading 14.8 gallons: mV = 639
Example: 1st reading empty: mV = 2731
2nd reading 2 gallons: mV = 2655
and so on to 9th reading 14.8 gallons: mV = 639