Wesael
Well Known Member
I made some very nice foam moulds for making some inlet transitions for my plenum setup on the RV-10.
Layed up the glass really nice and all turned out like I wanted but I din not check the type of foam I was using this time and found out it will not dissolve with paint thinner, or accitone. I think it it PVC foam looking back. Is there a way to get rid of it aside from chipping away at it with a screwdriver? this stuff is tough.
Layed up the glass really nice and all turned out like I wanted but I din not check the type of foam I was using this time and found out it will not dissolve with paint thinner, or accitone. I think it it PVC foam looking back. Is there a way to get rid of it aside from chipping away at it with a screwdriver? this stuff is tough.