PDA

View Full Version : Trutrak flat pack cutout


vmirv8bldr
05-03-2009, 09:29 AM
I had my panel cut, but the about half the holes need to be enlarged a fair amount. I went with a TruTrak AP, and selected the Flat Pack control head. However, to delay expense as much as possible, I don't physically have the head yet. So, does anyone have the dimensions for the cutout in the panel for a DGII Flat Pack? I looked all over TruTrak's website and didn't see it, and I searched here for quite a while to no avail.

If anyone has this head laying around and could measure for me, I would be grateful.

Thanks,
Bart

frazitl
05-03-2009, 10:02 AM
I have mine at the hangar. Could measure for you, but be aware that the corners are cut off of the face plate. That is, the cutout is a rectangle with each corner cut about 1/2" or so. I think it would be very hard to do a decent cutout without the flatpack in hand.

http://lh5.ggpht.com/_6G53xjXZY8U/Sf2_mj2pZlI/AAAAAAAAAOw/xUy0JdnLYQs/s720/IMG_2769.jpg

Radomir
05-03-2009, 10:04 AM
Send me your email address and I'll email it to you.. it's a PDF doc..

Mike S
05-03-2009, 12:04 PM
TruTrack emailed it to me.

SteinAir
05-03-2009, 08:56 PM
Hi Bart,

Drop me a line tomorrow of list and I'll send you a 100% drawing or a CAD file of it. Who cut your panel? You shouldn't need to mod the holes if the originating CAD file was good....(now if we cut it, call me a chew me out, because that shouldn't happen)! :) Our CNC usually will cut holes within a couple thou of what we tell it to.

Cheers,
Stein

Richard Connell
05-04-2009, 04:10 AM
http://i40.tinypic.com/e0jwq9.jpg