jsharkey
Well Known Member
Apologies to any seasoned carpenters out there but here is how I cut the gear stiffeners with a "Skill" saw.
(Still deciding whether to use them or not - but they are ready!)
Jim Sharkey
RV6 - Getting there!
Screw wood molding to a piece of spare plywood
Flip upside down and screw plywood to edge of bench
Set balde at 30deg and cut along line previously marked on back of molding
Viola!
(Still deciding whether to use them or not - but they are ready!)
Jim Sharkey
RV6 - Getting there!
Screw wood molding to a piece of spare plywood
Flip upside down and screw plywood to edge of bench
Set balde at 30deg and cut along line previously marked on back of molding
Viola!